Edge Detection
Draws lines where the layer's lightness, color, or transparency changes, so you can take the outlines of a picture as line art or as a mask. The original picture can be hidden, shown behind the lines, or shown in front of them, which leaves an outline around it. This effect requires GPU textures and GLSL execution.
Library location
Library → Filter Effect → Edge Detection
Properties
Detect (Target)
What a change is measured in.
- Type:
EdgeDetectionTarget - Default:
EdgeDetectionTarget.Luminance - Animatable: Yes
The choices are:
Luminance: lines inside the picture, where it gets lighter or darker. Transparent parts count for nothing, so the picture's frame draws no line.Transparency: lines along the picture's outline, where it fades to transparent. The line reaches to both sides of the outline.Color: lines inside the picture, where its color changes in lightness, hue, or saturation. Two areas of the same lightness are separated when their hues differ. Transparent parts count for nothing.
Thickness
How far the line reaches to each side of an edge, in composition units.
- Type:
float - Default:
1 - Animatable: Yes
- Range:
[0, 1000]
Threshold
Changes smaller than this draw no line. A change from black to white, or from transparent to opaque, is 100.
- Type:
float - Default:
10 - Animatable: Yes
- Range:
[0, 100]
Strength
How dark a change past the threshold draws its line. At 100 the line is solid from a change 10 points past the threshold, at 50 from 20 points past, and at 20 from 50 points past. Lower, a line darkens with the size of its change. It does not change how far a line reaches.
- Type:
float - Default:
100 - Animatable: Yes
- Range:
[0, 100]
Color
Color of the lines.
- Type:
Color - Default:
#FFFFFFFF(white) - Animatable: Yes
Original
Where the original picture goes.
- Type:
EdgeDetectionOriginal - Default:
EdgeDetectionOriginal.Hidden - Animatable: Yes
The choices are:
Hidden: only the lines.Behind: the picture behind the lines.In front: the picture in front of the lines, which then show only around it and through its transparent parts.
Usage
For line art, keep Original at Hidden and lower Threshold until the lines you want appear. To outline a cut-out shape, choose Transparency and In front, then raise Thickness. Use Color when two areas of similar brightness should still be separated.