Skip to main content
Version: 2.0.0-preview

Ring Modulator

Multiplies the audio signal by a sine wave of Frequency, which turns each tone into the sum and the difference of the two frequencies. Use it for metallic, bell-like, or robotic voices. The sine wave is worked out from the time alone, so a constant Frequency gives the same result after a seek.

Library location​

Library → Audio Effect → Ring Modulator

Properties​

Frequency (Hz) (Frequency)​

Frequency of the sine wave the signal is multiplied by. Low values, below about 20 Hz, make the level pulse instead of changing the tone.

  • Type: float
  • Default: 440
  • Animatable: Yes
  • Range: [0, 5000]

Mix (%) (Mix)​

Balance between the original and the modulated signal. 0 leaves the signal unchanged and 100 is fully modulated.

  • Type: float
  • Default: 100
  • Animatable: Yes
  • Range: [0, 100]

Usage​

For a robot voice, set Frequency between about 30 and 100 Hz. For a bell-like sound, use a few hundred hertz and lower Mix to keep some of the original.

Source​

src/Beutl.Engine/Audio/Effects/RingModulatorEffect.cs